Fault Phenomenon Description: The wired NIC (Network Interface Card) is not recognized in the operating system, and networking cannot be established normally. In Device Manager under Network adapters, the Intel Ethernet Controller (3) I225-V... Read More | Share it now!
标签： mini computer
M9-12/13 generation configuration Auto power on
Step 1: Ensure that the computer is connected to a keyboard (preferably using a wired connection). Long press the power button for 2 seconds to switch on the computer. Quickly press the Del/Delete key on the keyboard to enter BIOS Setup. Step 2:... Read More | Share it now!
Common QA answers for M1-AMD series products
Q: What should I do if my computer enters BIOS directly after booting up and I can't enter the operating system desktop? (Applicable to M.2-SATA or 2.5-inch SATA protocol hard disk query) Upon entering BIOS, navigate to Advanced > IDE... Read More | Share it now!
Preinstalled Windows 11 22H2 OOBE Page Skip Networking Feature Steps
Summary:In 2022, factory minicomputers come pre-installed with the latest Windows 11 22H2 system. Initially, setting up a new computer or reinstalling the system requires network connectivity before logging into the Microsoft account to smoothly... Read More | Share it now!
How to enable Auto Power on?
Step 1:Open the chassis by removing the 4 screws on the bottom of the chassis with the power off. Step 2:Locate the PWRON1 pin on the motherboard Step 3:Prepare a 2.54 mm pitch jumper cap and insert it into pin 2 and pin 3 for power-on... Read More | Share it now!
Solution to Frequent Reset of Motherboard BIOS
Problem Description:Some computers that have been in use for a little while always have BIOS reset problems, and all the original settings in the BIOS are lost. Solution: (you can follow the steps below to check one by one)1, may be the CMOS... Read More | Share it now!
（P04-i5-3317U）How to Enable Auto Power on？
Step 1: Press the Switch (SW) button and then quickly tap the Del button on the keyboard to enter BIOS setup; Step 2: Select Chipset>PCH-IO Configuration>Configure Restore AC Power Loss to Power On in order after entering BIOS... Read More | Share it now!
GT-i7-10870H How to turn on Auto Power on？
Overview: The GT-i7-10870H features a motherboard with a designated 3-pin PWRON1 connector. By default, the power-on self-start function is disabled. Follow the steps below to enable this function. Tools Needed: 1*Cross screwdriver 1*5mm... Read More | Share it now!
How to configure multiple networks (Ethernet, WLAN, 4G) to connect to the Internet, Windows domains, or both simultaneously under the Windows 10-11 system?
How to configure multiple networks (Ethernet, WLAN, 4G) to connect to the Internet, Windows domains, or both simultaneously under the Windows 10-11 system? Step 1: Right click on the start menu to open Run, Run, type "gpedit.msc" to open the "Local... Read More | Share it now!
H2-J4125 How to turn on Auto Power on?
Step 1: Press the switch button and then quickly hit the keyboard Del key to enter the BIOS Setup, after entering the BIOS, select Chipset> Set Restore AC Power Loss to Power on. Step 2: Press F10 to save and exit after setting is complete. ... Read More | Share it now!